Dual optical SAT outlet for two receivers
BFR-02

Ordering guide
BLANKOM BFR-02
Select BFR-02 for two independently controlled coaxial outputs and allow for two SC/APC fibres. BFR-01 serves one tuner on one fibre.
At a glance
Connections and equipment
Signal path · Two fibres · Two receiver outputs · Independent return paths

System diagram

Technical overview
The connected tuner sends 13/18 V for polarisation, 0/22 kHz for the low/high band and DiSEqC for the satellite position into the outlet’s coaxial F output. The outlet relays the commands upstream at 1310 nm. The BFM-1732C receives them at its optical subscriber port, selects the requested SAT-IF path and sends it downstream at 1550 nm.
Typical applications
At a dual-tuner recording position, run each tuner input to its own F connector. The two optical paths also suit two separate receivers sharing the same installation point.
System selection
Select BFR-02 for two independently controlled coaxial outputs and allow for two SC/APC fibres. BFR-01 serves one tuner on one fibre.
BLANKOM BFR-02 Application Diagram
Technical specifications
| Inputs | 2 × SC/APC |
|---|---|
| Outputs | 2 × F, 75 Ω |
| Satellite IF range | 950–2150 MHz |
| Terrestrial RF range | 47–870 MHz |
| Optical directions | 1550 nm downstream / 1310 nm upstream |
| Maximum optical input | 2 mW |
| Power supply | From the connected satellite receiver |
| Dimensions | 73 × 100 × 33 mm |
| Operating temperature | −15 … +40 °C |
Technical data applies to the stated model.
Engineering FAQ
Can two tuners choose satellite paths independently?
Yes. Each tuner uses its own F output, optical connection and headend port. The two paths can request different satellite positions or polarisation bands.
What should be specified for a quotation?
Select BFR-02 for two independently controlled coaxial outputs and allow for two SC/APC fibres. BFR-01 serves one tuner on one fibre.

